This is the same silicon... remember?...
running Claymore in dual mode on low dcri.
I see on two platforms so far - intel 1150 and 1151 that the best performance I can achieve is if I run corers of 470 at 1080-1090, to provide better loads for more powerful 480 I clock it to 1120.
Mem target is 2000 with stripes from 1500 and voltage for both core and mem is set to 857-864 depending on the card.
Stable WinX, cards are
+70C.
Power off the wall: for two systems in a box:) - total 9 cards 1380W
five cards on h97 anniversary:
![]()
smaller system with 4 mixed cards on 1151= 610W:
![]()
platforms: debloated winX, no full drivers install, watttool, vnc, run at about 60-70W for 4GB RAM, SSD, celeron(no active cooling)
will now fix air intake from outside, get cooler, pack tighter and ++dcri
running Claymore in dual mode on low dcri.
I see on two platforms so far - intel 1150 and 1151 that the best performance I can achieve is if I run corers of 470 at 1080-1090, to provide better loads for more powerful 480 I clock it to 1120.
Mem target is 2000 with stripes from 1500 and voltage for both core and mem is set to 857-864 depending on the card.
Stable WinX, cards are
+70C.
Power off the wall: for two systems in a box:) - total 9 cards 1380W
five cards on h97 anniversary:
smaller system with 4 mixed cards on 1151= 610W:
platforms: debloated winX, no full drivers install, watttool, vnc, run at about 60-70W for 4GB RAM, SSD, celeron(no active cooling)
will now fix air intake from outside, get cooler, pack tighter and ++dcri