Hello all,
I searched for days and tried everything that seemed like a solution, but I'm slowly giving up hope of getting my rig to work. I have mined perfectly in 2015 with 280x cards, but for some reason I can not get rx 480 cards to behave.
I can mine without issues when inserting only 1 GPU either directly onto the MB or with a powered riser. Only when inserting 2 or more GPU's with risers, added card(s) drops to 0MH/s within seconds, but only for the GPU(s) that are not in the "main" PCI-e slot. The "main" GPU never causes the crash. After halting to 0MH/s my rig freezes. When I notice my hashing going down to 0MH/s on a card and I can still quickly close the miner, my catalyst driver crashes.
At the time of freezing, GPU-z reads 0% on memory controller load on the crashed card(s).
My setup:
Gigabyte 990FXA-UD5 (newest firmware)
Amd sempron 145
Corsair RM1000
4x Asus RX 480 Dual OC 8GB
2x4 GB Ram
SSD 60gb
Windows 10 64bit pro
Virtual memory set to 16gb
Powered risers rev006
Current driver: 16.9.1
Mining ETH with Claymore 9.4
GPU temps are 65°C
I have also tested on a Asrock Z97 Extreme 4 motherboard (newest firmware), tried different risers (even old ribbon risers), all with similar results.
I have tried setting PCI-e gen to auto/1/2/3 on the Z97 mobo, the 990FXA doesn't even have this option.
I tried different miners (qtminer)
Is there anyone that can help me with some advice?
I searched for days and tried everything that seemed like a solution, but I'm slowly giving up hope of getting my rig to work. I have mined perfectly in 2015 with 280x cards, but for some reason I can not get rx 480 cards to behave.
I can mine without issues when inserting only 1 GPU either directly onto the MB or with a powered riser. Only when inserting 2 or more GPU's with risers, added card(s) drops to 0MH/s within seconds, but only for the GPU(s) that are not in the "main" PCI-e slot. The "main" GPU never causes the crash. After halting to 0MH/s my rig freezes. When I notice my hashing going down to 0MH/s on a card and I can still quickly close the miner, my catalyst driver crashes.
At the time of freezing, GPU-z reads 0% on memory controller load on the crashed card(s).
My setup:
Gigabyte 990FXA-UD5 (newest firmware)
Amd sempron 145
Corsair RM1000
4x Asus RX 480 Dual OC 8GB
2x4 GB Ram
SSD 60gb
Windows 10 64bit pro
Virtual memory set to 16gb
Powered risers rev006
Current driver: 16.9.1
Mining ETH with Claymore 9.4
GPU temps are 65°C
I have also tested on a Asrock Z97 Extreme 4 motherboard (newest firmware), tried different risers (even old ribbon risers), all with similar results.
I have tried setting PCI-e gen to auto/1/2/3 on the Z97 mobo, the 990FXA doesn't even have this option.
I tried different miners (qtminer)
Is there anyone that can help me with some advice?