I setup a mining rig with the following:
ASUS ROG H270f Gaming mobo [BIOS up-to-date]
Windows 7 PRO 64-bit [up to date]
4Gb DDR4 DIMM
(4) Gigabyte Geoforce 1050Ti WF OC Graphics cards
Intel Celeron Dual Core Processor
Corsair RM1000x PSU
Corsair 60Gb SSD
When I plug in 4 GPUs to the board, the rig would not boot up but if it's 3 GPUs it would boot up and run fine though I would be unable to go into BIOS setup unless it's only 1-2 GPUs. I have enabled and disabled so many options in BIOS but it wouldn't host 4 GPUs.
The board has 4 PCIEX_1 and 2 PCIEX_16 slots. One of the PCIEX_16 slots runs at a lower mode.
I have also tried to plug them in, in different sequences to no avail. Am at the end of my tether. I am going insane trying to figure this out. Please help!
Cheers
ASUS ROG H270f Gaming mobo [BIOS up-to-date]
Windows 7 PRO 64-bit [up to date]
4Gb DDR4 DIMM
(4) Gigabyte Geoforce 1050Ti WF OC Graphics cards
Intel Celeron Dual Core Processor
Corsair RM1000x PSU
Corsair 60Gb SSD
When I plug in 4 GPUs to the board, the rig would not boot up but if it's 3 GPUs it would boot up and run fine though I would be unable to go into BIOS setup unless it's only 1-2 GPUs. I have enabled and disabled so many options in BIOS but it wouldn't host 4 GPUs.
The board has 4 PCIEX_1 and 2 PCIEX_16 slots. One of the PCIEX_16 slots runs at a lower mode.
I have also tried to plug them in, in different sequences to no avail. Am at the end of my tether. I am going insane trying to figure this out. Please help!
Cheers