Booting problems in eth OS

Hello fellow miners!

I have encounterd a problem on my new rig. Speccs below:

Radeon RX 480 RS Triple X 8GB - 6 pcs
Intel Pentium G4400 Skylake Processor - 1 pcs
Corsair HX1000i, 1000W PSU - 1pcs
Crucial DDR4 2133MHz 4GB - 1 pcs
MSI Z170A GAMING PRO CARBON, S-1151 - 1 pcs

Im running ethOS on the rig.

So to the problem,

Basically when I boot or reboot ethOS I get a bugged out screen, just like when you tried to start an old SEGA- or nintendo 8-bit game and the picture is just whack!

To get the rig to boot into ethOS correctly I have to:

1. enter motherboard BIOS.
2. Disable 4g decoding.
3. Continue to boot ethos knowing it will fail and wait for "kernel panic end"
4. Reboot into BIOS.
5. enable 4g decoding.
6. Sucessfully boot into ethOS to continue mining.

Its so weird!!

I can't figure out the problem, it works perfectly when I boot according to the steps above, but when I do a regular reboot from a successful mining session that weird failure screen comes up!

Anyone with the same problem??

Any suggestions for a solution??


Thanks in advance for any help!!

Kindest regards!