Hey Guys,
I am new in mining and just build my first rig.
So far so good. Yesterday i installed all my 6 GPU's and installed the 16.9.2 driver.
At first mining with all 6 cards worked fine, but then 3 cards crashed and the miner restartet automaticly.
Now one of the six cards was turned of by the system because of a mistake. (Code 43)
I reinstalled the driver and it worked for about an hour, than crashed again.
I am mining on 5 cards now and it works for several hours.
I am not sure yet which card it is. The device manager says its PCI bus 2. I think this could be the PCI-E 16x slot.
I am at work yet so I wasn't able to change the hardware and check if the card is broken.
Is there something i have to set for the 16x slot to work well?
the card on the 16x slot is also the card where my monitor is pluged.
Sorry if there is allready a thread about. My english isn't the best and I did not found anything about.
I am new in mining and just build my first rig.
So far so good. Yesterday i installed all my 6 GPU's and installed the 16.9.2 driver.
At first mining with all 6 cards worked fine, but then 3 cards crashed and the miner restartet automaticly.
Now one of the six cards was turned of by the system because of a mistake. (Code 43)
I reinstalled the driver and it worked for about an hour, than crashed again.
I am mining on 5 cards now and it works for several hours.
I am not sure yet which card it is. The device manager says its PCI bus 2. I think this could be the PCI-E 16x slot.
I am at work yet so I wasn't able to change the hardware and check if the card is broken.
Is there something i have to set for the 16x slot to work well?
the card on the 16x slot is also the card where my monitor is pluged.
Sorry if there is allready a thread about. My english isn't the best and I did not found anything about.