Hello everyone! Can any of you please help me understand how to alter the BIOS with Polaris BIOS Editor to accomplish getting the voltage timings to match up with WattTool?
I can get the following to run stable in Windows:
![]()
With these settings I am getting about 28 for ETH and 830 for DCR with each of my Sapphire RX 480 4GB (100406NT4GOCL).
My BIOS settings ATM:
![]()
When I changed the settings under GPU and Memory to match the above seen in WattTool I found my setup running at just over 1100W whereas after making the changes in WattTool my total system draw is a little over 700W which is obviously far more desirable...
Windows is really pissing me off with my third PCIE slot adapter being in a Code 43 state upon reboot at random and I need to switch to a Linux installation.
I can get the following to run stable in Windows:
With these settings I am getting about 28 for ETH and 830 for DCR with each of my Sapphire RX 480 4GB (100406NT4GOCL).
My BIOS settings ATM:
When I changed the settings under GPU and Memory to match the above seen in WattTool I found my setup running at just over 1100W whereas after making the changes in WattTool my total system draw is a little over 700W which is obviously far more desirable...
Windows is really pissing me off with my third PCIE slot adapter being in a Code 43 state upon reboot at random and I need to switch to a Linux installation.